Furuno NAVNET 1724C Manual de usuario Pagina 222
- Pagina / 247
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
8. MAINTENANCE, TROUBLESHOOTING
8-13
Note: Though the message “SYSTEM HAS FAILED START UP TEST. PLEASE
CONTACT A LOCAL FURUNO REPRESENTATIVE FOR REPAIR. PUSH ANY KEY TO
CONTINUE” may appear when powering on the display unit immediately after the clearing
memories, there is no problem in fact. Press any key to continue the operation.
8.9 Error Messages
In addition to alarm messages your equipment also displays error messages.
Error messages
Error Message Meaning Remedy
General
Connection with the ETR was
cut.
Network sounder disconnected. • Check that display unit
where the sounder is
connected is turned on.
• Check network sounder’s
cabling.
Connection with the RADAR
was cut.
Radar disconnected.
• Check that display unit
where the radar is
connected is turned on.
• Check antenna cable.
Low Voltage! Internal Battery
Voltage of battery on circuit
board in display unit is low.
Have a qualified technician
replace the battery.
No bearing pulse detected.
No bearing pulse from radar
antenna.
Check antenna cable.
No position data
No position data is present. Check for obstacles around
GPS antenna.
No GPS fix!
Possible problem with FURUNO
BB GPS receiver.
Disconnect GPS cable from
the display unit, and then
contact your dealer.
No heading pulse detected. Check heading sensor.
HEADING DATA MISSING!
No heading pulse
Check heading cable.
- IMPORTANT NOTICES 2
- SAFETY INSTRUCTIONS 3
- TABLE OF CONTENTS 4
- Declaration of conformity 8
- FOREWORD 9
- SYSTEM CONFIGURATIONS 10
- Two-unit NavNet system 12
- 1. OPERATIONAL OVERVIEW 14
- Plotter displays 15
- 1.1.2 Remote controller 16
- 1.2 Inserting a Chart Card 17
- 1.3 Turning the Unit On/Off 18
- .250/ 319.9 19
- 1.4.2 Hue 20
- 1.5 Selecting a Display 21
- 1.5.2 Selecting a display 22
- Select source menu 24
- Cursor, cursor data 25
- Destination 26
- 1.8 Data Boxes 27
- 1.9 Function Keys 28
- 1.10 Simulation Display 29
- 2. RADAR OPERATION 32
- 2.4 Adjusting the Gain 33
- 2.5 Reducing Sea Clutter 34
- 2.5.2 Adjusting the A/C SEA 35
- 2.7 Range Scale 36
- 2.8 Pulselength 37
- 2.9 Presentation Mode 38
- 2.10 Measuring the Range 40
- 2.11 Measuring the Bearing 42
- 1.5/ 319.9 44
- 2.15 Zoom 45
- Place cursor 46
- 2.17 Using the Offset EBL 47
- 2.18.4 Trail color 51
- 2.19 Echo Stretch 52
- 2.20 Echo Averaging 53
- 2.21 Outputting TLL Data 54
- 2.22 Guard Alarm 55
- 2.23 Watchman 56
- WATCHMAN TIME 57
- 5 minutes 57
- 10 minutes 57
- 20 minutes 57
- 2.24 Waypoint Marker 58
- 2.25 ARP, TTM Operation 59
- What is a vector? 63
- 2.25.8 CPA/TCPA alarm (ARP) 66
- 2.26.1 False echoes 68
- 2.26.3 Racon (Radar Beacon) 70
- Contents of nav data window 73
- 3.1.2 Nav graphic display 74
- Compass display 74
- XTE LIMIT 75
- QP<01> 76
- 3.1.3 Highway display 77
- 34° 34. 5678' N 78
- 120° 34. 5678' 78
- 3.2 Presentation Mode 79
- 3.5.1 Chart card overview 80
- 3.5.3 Navionics 82
- 124 24. 3456 W 59.9kt 024nm 83
- 3.5.4 C-MAP charts 85
- Object windows 86
- 3.6 Working with Track 89
- 3.6.3 Changing track color 90
- Own ship’s track 91
- 3.6.6 Erasing track 93
- 3.7 Marks, Lines 95
- 3.7.3 Selecting line type 96
- 3.7.4 Erasing marks, lines 97
- 3.8 Waypoints 98
- SELECT MARK 99
- 0 01WPT 100
- 3.8.2 Editing waypoint data 101
- Plotter display 102
- 3.8.3 Erasing waypoints 103
- 3. PLOTTER OPERATION 104
- 3.8.5 Searching waypoints 105
- 3.9 Routes 106
- 3.9.2 Connecting routes 109
- 3.9.3 Inserting waypoints 110
- 3.10 Navigation 112
- EXT WPT (RMB) 114
- INTERNAL 114
- 3.10.4 Following a route 116
- 3. Press the LOG soft key 117
- 3.11 Alarms 120
- 3.11.2 Arrival alarm 121
- 3.11.3 Anchor watch alarm 122
- 3.11.5 Speed alarm 123
- 3.11.6 Proximity alarm 124
- 3.11.7 Trip alarm 124
- 0 .250 nm 125
- 3.11.9 Alarm information 126
- 4. VIDEO SOUNDER OPERATION 130
- Bottom-zoom display 133
- A-scope display 134
- 4.3.4 Shifting the range 137
- 4.4 Measuring Depth, Time 138
- 4.5 Reducing Interference 138
- 4.7 Erasing Weak Echoes 140
- 4.9 Picture Advance Speed 141
- 4.10 Display Colors 143
- 4.11 Alarms 144
- 4.11.2 Bottom alarm 145
- 4.11.4 Fish alarm (B/L) 146
- FISH ALARM! 147
- Message Meaning 148
- 4.15.1 Zero line 149
- 4.15.2 Bottom echo 150
- 4.15.3 Fish school echoes 151
- 5. AIS OPERATION 152
- 5.2 AIS Symbols 154
- 5.4 Activating Targets 155
- 5.5 Displaying Target Data 155
- 5.6 Lost Target 156
- 5.7 Setting CPA and TCPA 156
- 5.8 Proximity Alarm 157
- 5.10 Choosing Vector Time 158
- 6. DATA TRANSFER 160
- Upload and download menus 163
- Route data menu 165
- Mark data menu 166
- 7. CUSTOMIZING YOUR UNIT 170
- 7.2 Radar Setup 173
- (Con’t on next page) 174
- 7.2.2 Radar range setup 176
- 7.2.3 Function key setup 177
- 7.3 Plotter Setup 179
- 7.3.2 Function key setup 180
- Plotter function keys 182
- 7.4.1 Chart offset 183
- Page 1 Page 2 184
- Page 2Page 1 185
- SAFETY STATUS indication 188
- 7.5 Data Boxes Setup 191
- 7.6 Hot Page Setup 192
- 7.7 Navigator Setup 193
- Contents of nav setup menu 194
- SETUP 198
- < − −> 199
- 7.8 Nav Data Display Setup 201
- 7.9 Sounder Setup 202
- depth and water 204
- 7.9.2 Sensor setup 205
- 7.9.4 Function key setup 207
- Sounder function keys 208
- 8. MAINTENANCE 210
- TROUBLESHOOTING 210
- 8.3 Replacement of Fuse 211
- 8.4 Replacing the Magnetron 212
- 8.5 Simple Troubleshooting 212
- 8.5.2 Radar 213
- 8.5.3 Plotter 213
- 8.5.4 Sounder 214
- 8.6 Diagnostics 215
- PROGRAM No. *XXXXXXXXXX 216
- GPS UNIT : OK 216
- Machine Status +115 216
- 8.6.2 Test pattern 217
- Test pattern sequence 218
- I/R REMOTE CODE 219
- 8.7 GPS Status Display 220
- 8.8 Clearing Memories 221
- 8.9 Error Messages 222
- APPENDIX 224
- = Default setting 228
- ALARM key 232
- Geodetic Chart List 233
- M 234
- MODEL 1724C/1734C 236
Relacionado con productos y manuales para Receptor Gps Furuno NAVNET 1724C
Receptor Gps Furuno MU-150HD Manual de usuario
(28 paginas)
(28 paginas)
Receptor Gps Furuno GP-1610CF Manual de usuario
(20 paginas)
(20 paginas)
Receptor Gps Furuno GP-7000F Manual de usuario
(52 paginas)
(52 paginas)
Receptor Gps Furuno GP37 Manual de usuario
(2 paginas)
(2 paginas)
Receptor Gps Furuno GP-1850WF Manual de usuario
(115 paginas)
(115 paginas)
Receptor Gps Furuno GP-1650WDF Manual de usuario
(26 paginas)
(26 paginas)
Receptor Gps Furuno NX-300 Manual de usuario
(65 paginas)
(65 paginas)
Receptor Gps Furuno GP-1610C Manual de usuario
(16 paginas)
(16 paginas)
Receptor Gps Furuno DD-80 Manual de usuario
(119 paginas)
(119 paginas)
Receptor Gps Furuno GP-1850W Manual de usuario
(4 paginas)
(4 paginas)
Receptor Gps Furuno GP-330B Manual de usuario
(28 paginas)
(28 paginas)
Receptor Gps Furuno GP-320B Manual de usuario
(20 paginas)
(20 paginas)
Receptor Gps Furuno RP-250 Manual de usuario
(73 paginas)
(73 paginas)
Receptor Gps Furuno GP-1850D Manual de usuario
(94 paginas)
(94 paginas)
Receptor Gps Furuno GP-7000F Manual de usuario
(132 paginas)
(132 paginas)
Receptor Gps Furuno GD-1700C Manual de usuario
(50 paginas)
(50 paginas)
Receptor Gps Furuno GP-1650WD Manual de usuario
(96 paginas)
(96 paginas)
Receptor Gps Furuno GP-30 Manual de usuario
(2 paginas)
(2 paginas)
Receptor Gps Furuno GP-3500 Manual de usuario
(192 paginas)
(192 paginas)
Receptor Gps Furuno GP-1850 Manual de usuario
(13 paginas)
(13 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.062 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales